Are you always looking for a better printed circuit board (PCB), but you’re failed to do it in most of time? Well, don’t waste your time anymore for the searching; instead, you can use the precious time to design a better PCB here!

Before that, most of you have learned that PCB fab houses, such as advanced circuits, Batch PCB, PCB123 and other are quite hard job to do with. Hence, it’s not an easy task, as there are many ways for a fab house to mess it up! Moreover, fab houses tend to spend less time on prototypes than on production runs. To overcome the matter, you should try to design PCBs for manufacturability. The main goal of this project is to show you how to minimize the number if ways the fab houses can screw up a PCB!

For avoiding yourself from mess up with the PCBs, you would like to refer to some of the finest DFM (design for manufacture) rules, tricks and tips on how to build a good PCB. And, if you’re trying to create a prototype PCB, then you must use these rules and tips to increase the chances that your prototype will work after you’ve done with it!

Blogsphere: TechnoratiFeedsterBloglines
Bookmark: Del.icio.usSpurlFurlSimpyBlinkDigg
RSS feed for comments on this post  |  TrackBack URI for this post

This entry was posted on Saturday, November 22nd, 2008 at 2:16 am and is filed under Electronics Tutorial. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.