Comments on: AVRJTAG clone in action

By: madgrey

madgrey — Thu, 16 Sep 2010 21:13:58 +0000

2 JTAG CLONE error: Test connection VCC to PA2…

By: JTAG CLONE error

JTAG CLONE error — Thu, 16 Sep 2010 19:03:14 +0000

[...] CLONE error Hi. I bild a JTG Clone from here: AVRJTAG clone in action – Scientific, embedded, biomedical, electronics contents. but avr studio says THE OCD JTAG Ada[pter was detected ,but there is no targer power... On the [...]

By: Arek

Arek — Sat, 27 Mar 2010 10:41:31 +0000

Hi, Can I use this programmer for XMEGA?

By: Machta

Machta — Mon, 08 Mar 2010 17:18:25 +0000

You can use it,but you have to recompile boot loader for your controller with good frequency.:)

By: Mansoor

Mansoor — Sun, 27 Dec 2009 19:31:11 +0000

No one answer that “Can mega32 be used instead of Mega16″?I also have a lot of meag32 but no mega16.

By: avrvi

avrvi — Mon, 01 Jun 2009 09:03:09 +0000

AVR JTAG ICE MKII Clone

By: vport

vport — Mon, 29 Sep 2008 07:04:25 +0000

same error as angle
Iâ€™ve build this JTAG loaded the bootloader, when I try to upgrade the ATmega163 is selected, and I get a verification error to, and offcourse I canâ€™t connect to the JTAG adapter trough AVRStudio.

Please explain this errors, and give some answer.

By: Slavko

Slavko — Wed, 13 Aug 2008 12:40:55 +0000

Hi, is this AVRJTAG works with ATMega48/88/168, has anyone try to use it for these microcontroller?

By: dquang

dquang — Tue, 27 May 2008 10:28:21 +0000

I tried this JTAG, it’s create. And I also edited this JTAG into the USB version because my laptop do not has the COM port.
It really useful to remove bugs in your source code.
But the among of support chip is small, only 8 chips in AVR 4.07 and 9 chips in AVR 4.14.
Anyway, thanks for your job scienceprog!
I am starting to build other type od JTAG which can support more AVR chip.

Luong Vu Dang Quang

By: Nedsan

Nedsan — Tue, 27 May 2008 08:18:04 +0000

Hi. I’ve made this JTAGice but I get “Not supported board found. AVRprog version 1.40″. I get this massage even when no board is connected to my PC. I’ve made my own target board with a new Atmega16. I’ve programmed the bootloader to another Atmega16, which I placed in the Jtag board. I’ve got power supply wherever I need one. Still no result from my attempts. Can you give me some directions. Thanks.